Chart Patterns: Reversals, Continuations and Targets
By Chad Smith, Director of Research & Analysis · Updated
On this page
In this lesson you will learn
- Tell reversal patterns from continuation patterns
- Identify head and shoulders, double tops and bottoms, triangles, flags and wedges
- Confirm a pattern with a neckline or boundary break
- Set entries, stops and measured-move targets
Chart patterns are shapes that price traces as it moves between support and resistance and through trends. This lesson explains the two families of patterns, the most widely followed examples, and the standard method for entries, stops and targets. Each pattern has its own page in our chart patterns library.
Two families of patterns
Chart patterns fall into two groups:
- Reversal patterns suggest a trend may be ending and turning the other way. Examples: head and shoulders, double tops and bottoms.
- Continuation patterns suggest a pause within a trend before it carries on. Examples: flags, pennants and many triangles.
Some patterns, such as symmetrical triangles, can break either way. Context decides how to read them, so always start with the trend.
Head and shoulders
The head and shoulders top is one of the best-known reversal patterns. It forms after an uptrend:
- Left shoulder: a rally and pullback.
- Head: a higher rally and a pullback to around the same level as before.
- Right shoulder: a lower rally that fails to reach the head.
- Neckline: a line connecting the two pullback lows.
The pattern is only confirmed when price closes below the neckline. Until then it is just a possible pattern. In structure terms, the right shoulder is a lower high and the neckline break is a lower low, the same break of structure you learned in the trends lesson.
The inverse head and shoulders is the mirror image at the bottom of a downtrend.
Double tops and double bottoms
A double top forms when price rallies to a level twice and fails both times, with a pullback low between the peaks. The neckline is the low between them. A close below it confirms the pattern.
A double bottom is the reverse: two lows at about the same level, with confirmation on a close above the high between them. Triple tops and bottoms follow the same logic with a third test.
Triangles
Triangles form when price swings in a narrowing range.
- Ascending triangle: flat resistance on top and rising lows underneath. Buyers are getting more aggressive, so it is often read as bullish.
- Descending triangle: flat support and falling highs, often read as bearish.
- Symmetrical triangle: falling highs and rising lows, a sign of consolidation. It is usually traded in the direction of the breakout.
Flags and pennants
A bull flag forms after a sharp rise, called the pole. Price then drifts slightly lower in a small, tidy channel, the flag. A break above the flag suggests the trend is continuing. A bear flag is the reverse.
A pennant is similar, but the pause forms a small symmetrical triangle instead of a channel. Both patterns are short; if the pause becomes long and messy, it is no longer a flag.
Wedges
A rising wedge has both boundaries sloping upward, with the lower line rising faster, so the range narrows as price climbs. It is often read as bearish, because each push higher gains less ground. A falling wedge is the reverse and is often read as bullish.
Confirming a pattern
A shape that looks like a pattern is not yet a pattern. Traders look for:
- A clear prior trend for reversal patterns, or a strong pole for flags.
- A breakout: a close beyond the neckline or boundary, not just a wick.
- Follow-through: the next candles continue in the breakout direction.
- Context: the pattern sits at a meaningful level on a higher timeframe.
Some traders also wait for a retest of the broken neckline before entering, accepting that they will sometimes miss the move.
Entries, stops and targets
Most patterns are traded with the same framework.
Entry: on the break of the neckline or boundary, or on a retest of it.
Stop-loss: on the other side of the pattern's last swing. For a head and shoulders top, that is often above the right shoulder.
Target: a measured move. Measure the height of the pattern and project it from the breakout point.
Worked example (illustrative numbers): a double bottom on AUD/USD has lows at 0.6500 and 0.6505 and a neckline at 0.6580. The height is about 80 pips. Price closes above 0.6580 at 0.6588. The measured-move target is about 0.6580 + 0.0080 = 0.6660. A stop below the second low might sit at 0.6495, which is 93 pips from the entry. The trader compares 93 pips of risk with 72 pips of remaining reward and decides the ratio is poor. They wait for a retest of the neckline near 0.6580 instead, which would allow a tighter stop under the retest low.
That last step matters. A measured move is an estimate, not a promise, and the trade still has to offer acceptable risk and reward. The risk course explains this in risk/reward and win rate.
Limitations
- Hindsight. Patterns are easy to see after they complete and much harder in real time.
- Subjectivity. Two traders may draw the same pattern differently.
- Fakeouts. Many breakouts fail and return inside the pattern.
- No fixed reliability. How often a pattern works depends on the market, timeframe and conditions. Test any pattern-based rule yourself, as shown in the backtesting lesson.
Key takeaways
- Reversal patterns suggest a trend may end; continuation patterns suggest a pause before it continues.
- Head and shoulders, double tops and bottoms, triangles, flags and wedges are the core patterns.
- A pattern is confirmed only by a close beyond its neckline or boundary.
- Stops go beyond the pattern's last swing, and targets often use a measured move.
- Patterns are subjective and often fail, so combine them with context and test them.
Check your understanding
1. What confirms a head and shoulders top?
- A. The right shoulder forming
- B. A close below the neckline
- C. Any bearish candle
- D. A rise above the head
Show answer
B. A close below the neckline
2. Which pattern is usually treated as a continuation pattern?
- A. Double top
- B. Head and shoulders
- C. Bull flag
- D. Triple bottom
Show answer
C. Bull flag
3. How is a measured-move target for a double bottom usually estimated?
- A. The height from the lows to the neckline, projected up from the breakout
- B. Twice the spread
- C. The distance to the nearest round number
- D. The size of the last candle
Show answer
A. The height from the lows to the neckline, projected up from the breakout
Brokers with strong charting to practice on
Put this into practice on a demo account first, with no money at risk.
- Featured broker
Pepperstone4.7 / 5Visit
IC Markets4.9 / 5Visit
GO Markets4.8 / 5Visit